Pre / Post Processing

Not just milling, but sanding too!

CNC milling may be our main service, but it's only one step in the majority of projects out there. To get your project where it actually needs to be might require a lot of extra manual tasks along the way, both before and after. We might have to surface or cut down material to a specific length to fit into a fixture, or square up and glue a lot of boards into an edge-glued solid panel for a tabletop or wall sculpture.

After milling maybe you need threaded inserts or studs installed for future assembly. Tabs that were used to hold parts in manufacturing might need to be manually removed, and angled or very deep cuts that might be easier and faster on a tablesaw may need to be handled. After that we can offer sanding or assembly services to get your project ready for finish--and in some cases we may be able to offer a finishing service to you as well.

material prep

pre-dimension or glue up stock for milling


remove the hairy bits left from milling

manual cuts and ops

table-saw mitering, squaring corners, adding inserts

sanding and finishing

from raw wood to finished surface

tell us all about your project needs.

Don't be a stranger, now! We'd love to see how we can help you get where you need to go. Even if that means in the middle of nowhere, sleeping well, knowing that your project is getting taken care of back home.

outdoors shot around evening on a dirt road with chaparral and slightly snowy cloud covered mountains in the distance
arrow for link

CNC Milling / Routing

Not your dad's handheld router

arrow for link


you gotta test before you invest

arrow for link